Cleaning a greasy gas stove and range hood: how to remove, soak and wipe without damaging them
Quick answer: turn off the gas (or unplug the induction hob and range hood) and let everything cool. Remove the grates, burner caps and the hood’s metal grease filters, soak them in warm water with dishwashing liquid and a few spoons of baking soda for 15–30 minutes, scrub with a soft brush, rinse and dry completely before refitting. Wipe the cooktop and hood body with a soft cloth only; no metal scourers.
Why clean regularly?
- Burner holes clogged with grease and spills give an uneven, orange flame and poor ignition.
- Filters full of grease make the hood weak, noisy and smelly.
- Old grease oxidises and hardens, becoming much harder to remove than fresh grease.
What you need
- Gloves and a basin or sink big enough to soak parts.
- Warm water (about 50–60°C), dishwashing liquid, baking soda.
- Soft brush, toothpick or fine needle for burner holes, soft cloths.
Gas stove: grates and burners
- Close the gas valve and wait until the stove is cold.
- Lift off the grates and burner caps.
- Soak in warm water with dishwashing liquid + 2–3 spoons of baking soda for 15–30 minutes.
- Scrub with a soft brush. Clear blocked flame holes gently with a toothpick or needle without enlarging them.
- Rinse and dry completely. Damp burners light poorly.
- Refit correctly, open the valve and test: an even blue flame means you’re done.
Glass, induction and stainless cooktops
- Clean only when cool. Put a few drops of dishwashing liquid on a damp cloth, wipe in one direction, then wipe with a clean damp cloth and dry.
- Burnt-on marks on glass: apply a paste of baking soda and a little water for 10–15 minutes, then wipe, or use a cooktop glass scraper held at an angle.
- Avoid metal scourers and abrasive powders that scratch glass and steel.
- Induction and radiant hobs: don’t let water run into the control panel.
Range hood
- Unplug or switch off at the breaker.
- Remove the metal grease filters (usually clipped underneath).
- Soak in hand-hot water with dishwashing liquid and baking soda for 20–30 minutes, brush gently along the mesh, rinse and dry.
- Wipe the body and underside with a damp cloth and a few drops of dishwashing liquid; wipe stainless steel along the grain.
- Recirculating hoods have charcoal filters: these cannot be washed; replace them as the manufacturer recommends.
Grease-cutting dishwashing liquid such as SPY Dishwashing Liquid or URA Dishwashing Liquid works well for soaking grates, burners and filters.
How often?
| Part | Daily cooking | Occasional cooking |
|---|---|---|
| Cooktop surface | After each use | After each use |
| Grates and burners | Every 1–2 weeks | Monthly |
| Metal hood filters | Every 2–4 weeks | Every 1–2 months |
| Charcoal filters | Per manufacturer | Per manufacturer |
Safety notes
- If you smell gas: no flames, don’t touch electrical switches, open windows, close the valve and call a technician or your gas supplier.
- Don’t combine strong cleaners with dishwashing liquid, and never mix cleaning products.
- Replace burners that are warped, cracked or badly rusted.
Read more: Greasy, slippery kitchen floor · Smelly kitchen sink that drains slowly · Deep cleaning before Tet · Ants and cockroaches: keeping the kitchen floor clean
Reviewed by: Vu Hoang Nam, Head of Marketing
← More home care guides